If a new cement pole mold is hoisted onto a centrifuge, it should be slowly raised from low speed to high speed for no-load operation. During operation, ensure smooth movement; only when there is no jumping should materials be added for production. Operators should possess the relevant operating skills and use the mechanical mold according to the operating procedures. Below is a brief introduction to some methods and precautions for using cement pole molds.

1. After opening the cement pole mold, apply release oil to both the upper and lower molds. Then, add the reinforcing cage to the bottom mold, evenly distribute the concrete, and smooth it out, ensuring there is no concrete on the wedge. Then close the mold. When closing the mold, ensure no soil falls onto the wedge; if any, it must be opened and cleaned again.

2. When tightening the mold closing screws, tighten them simultaneously from both ends to the other. The tightness of the screws depends on their position; otherwise, the mold may deform.

3. When reusing the mold, ensure the wedge is clean to prevent leakage. Applying wax will improve the effect. Take care to avoid injury during operation.

4. When placing the centrifuge stool, gently lower it onto the running wheel. Centrifuge at low speed for 2 minutes at 10Hz; at medium speed for 3 minutes at 25Hz; and at high speed for 6 minutes at 50Hz.

5. When entering the aeration tank, ensure the tank floor is level. 6. When stacking, ensure the running wheels align to prevent deformation of the mold.

7. When opening the mold, both ends should be opened simultaneously. The bottom mold should be lifted simultaneously by all four lifting rings. After the pole is removed, clean the mold along the rings. Never remove the pole in an inverted manner, and prevent collisions.

8. Safety must be paramount during lifting. Molds must never be allowed to walk over workers' heads.

This concludes the precautions for using cement pole molds. We hope this information is helpful. For those interested in purchasing mechanical molds, please visit Qingzhou Hexie Building Materials!