The cement pipe mold features a reinforced, leak-proof design. The pipe joints are smooth and burr-free, and mold opening is simple and easy. The friction ring inside the mold is made of high-quality cast steel, offering excellent wear resistance. Operators using the machinery should understand its structure and operation. Below are the assembly steps and precautions for the mold.

1. Carefully apply machine oil to the spigot ring of the cement pipe mold and install a gap bolt to ensure a proper clearance between the inner side of the steam-cured spigot ring and the pipe spigot, preventing damage to the pipe spigot when removing the spigot ring.

2. Evenly apply clean machine oil to the inner wall of the outer mold. Close the mold outside the reinforcing steel frame, connecting the joint bolts, taking care to prevent the reinforcing steel ends from getting stuck in the joint.

3. Tighten the joint connecting bolts in sequence, using moderate tightening force to prevent grout leakage and avoid causing the mold to become out of round. To facilitate the smooth installation of the spigot ring into the top of the outer mold later, temporarily avoid fully tightening the two bolts at the upper part of the joint on both sides; tighten them after the spigot ring is in place.

This concludes the brief introduction to the cement pipe mold installation process and precautions. For more detailed information on cement pipe making machinery, molds, etc., please contact us by phone.

7. If any malfunctions occur during use that you cannot resolve yourself, seek assistance from professionals or technicians.

Proper operation and maintenance of cement pipe-making machinery are essential to minimize malfunctions and extend its lifespan. For those interested in purchasing related machinery, please feel free to contact us.