Cement pipe making machinery is a type of mechanical equipment used to manufacture cement pipes. Cement pipe making can be divided into two main components: the machinery itself and the mold. Based on their structural form, pipe making machinery can be classified into two types: roller-type pipe making machines and centrifugal pipe making machines. These machines are characterized by their simple operation and convenient maintenance. When using the machinery, it is important to pay attention to the correct operating methods. The relevant operating precautions are as follows:

1. Before starting the machine, first check that all transmission connections of the cement pipe making machine are normal. Then, remove the positioning pins, pull the movable gantry outwards and rotate it 90° to disengage the suspension roller shaft from the gantry and support, placing it in a free state. After the suspension roller pipe making mold is lifted by the overhead crane and fitted onto the suspension roller shaft, close the gantry, allowing the suspension roller shaft to be supported within the sleeve. Insert the positioning pins into the positioning holes, then lower the cement pipe making mold, ensuring that the inner holes of the retaining rings at both ends of the mold press against the suspension shaft. Remove the wire rope, move the overhead crane away, and prepare to start the machine.

2. Start the speed-regulating motor to allow the suspension roller shaft to drive the mold to idle. After normal operation, start the conveyor to begin feeding material into the hopper, and then feed it into the mold via the feeder conveyor belt. Under the action of centrifugal force, roller pressure, and vibration, the concrete is gradually compacted and formed. After forming, remove the feeder belt from the mold, and finally turn off the main motor.

3. Use a crane to lift the compacted mold, so that the suspension roller shaft is suspended from the inner wall of the mold. Open the gantry, and use the crane to slowly move the mold out, detaching it from the suspension roller shaft. Place it on a curing trolley and send it into the kiln for steam curing. Finally, return the movable gantry to its original state, completing the entire production process of one concrete pipe.

This concludes our introduction to the key points for using cement pipe making machinery. For more information about machinery and equipment, please feel free to contact us by phone.