Shandong pole molds are used in the production of cement poles and pipes. Operators must pay attention to correct operating procedures. When hoisting a new mold onto the centrifuge, it should be raised slowly from low speed to high speed for a no-load test run. If there is no jumping or abnormal operation during the run, then material can be used for production. The following are some methods for using the molds:

1. After opening the Shandong utility pole mold, apply release oil to both the upper and lower molds. Then, add the reinforcing cage to the bottom mold, evenly distribute the concrete, and smooth it out, ensuring there is no concrete on the wedge. Only then can the mold be closed. Be careful to ensure no soil falls onto the wedge.

2. When tightening the mold closing screws, tighten them simultaneously from both ends to the other end. The tightness depends on how well the screws are in place.

3. When reusing the equipment, keep the wedge clean to prevent leakage. Applying wax will improve the effect.

4. Take care to prevent damage to the equipment during operation.

5. When loading the centrifuge, gently place it onto the running wheels. Centrifuge at low speed for 2 minutes at 10Hz, at medium speed for 3 minutes at 25Hz, and at high speed for 6 minutes at 50Hz.

6. When entering the aeration tank, ensure the ground is level. When stacking, place the running wheels side by side to ensure the mold does not deform.

That concludes our introduction to the use of Shandong utility pole molds. We hope this information is helpful. For more detailed information about cement pipe manufacturing machinery, please feel free to contact us by phone.